____________________________________________________________________________________
| Home / Car Engines / BMW Engines / BMW M43B16 |
BMW M43B16 Troubleshooting
| Engine hard to start or will not start |
Empty gas tank - Add gasoline.
Incorrect fuel grade - Use quality gasoline.
Clogged fuel system - Remove clogging.
Disconnected or loose spark plug wire - Inspect the spark plug wire connection, replace or repair.
Spark plug is faulty - Replace spark plug.
Defective ignition system - Check ignition and replace faulty components.
Fuel filter is clogged - Replace fuel filter.
Restricted fuel lines - Clean fuel lines.
Fuel pump is dirty or defective - Test fuel pump and change if necessary.
Clogged or defective fuel injectors - Clean or change fuel injectors.
Weak cylinder compression - Inspect cylinder block and change worn parts.
| Rough engine running |
Ignition failure - Check ignition and replace faulty components.
Air filter element is clogged - Change or service air filter.
Spark plug is damaged - Spark plug need to be replaced.
Clogged or defective fuel pump - Test fuel pump and change if necessary.
Improper valve clearance - Adjust to proper valve clearance.
Ignition timing is improper - Ignition timing needs to be set properly.
Incorrectly set low idle speed - Need to adjust idle speed.
| Engine starts and stalls immediately |
Damaged spark plug - Replace spark plug.
Fuel injectors are damaged or dirty - Clean or install new fuel injectors.
Defective ignition coil - Install a new ignition coil.
Bad or broken valve springs - New valve springs need to be installed.
Valves are stuck - Valves must be cleaned.
| Engine keeps overheating |
Engine oil insufficient - Fill the crankcase with engine oil.
Excessive engine load - Reduce engine load.
Fuel injectors are dirty - Clean or change fuel injectors.
Ignition timing is wrong - Set the ignition timing properly.
Incorrect valve setting - Set the valves properly.
Defective radiator cap or clogged radiator core - Clean radiator or replace cap.
Not enough coolant - Fill the cooling system and check components for leaks or other faults.
Damaged thermostat - Install new thermostat.
Damaged water pump - Change water pump as required.
| Abnormal engine knocking or noise |
Low octane fuel - Change gasoline.
Engine is under excessive load - Load reducing is recommended.
Engine oil level low - Fill up the engine oil.
Wrong adjustment of low idle speed - Test and adjust.
Fuel pump is clogged or faulty - Inspect fuel pump and change as required.
Worn crankshaft or main bearings - Install new parts as as required.
Improper valve clearance - Adjust valve clearance according to specifications.
Damaged cylinder bore or piston rings - Replace faulty components.
| Engine power is too low |
Fuel injectors are faulty or clogged - Inspect fuel injectors and change as required.
Dirty air filter element - Service or replace air filter.
Fuel pump is dirty or defective - Check fuel pump and change if required.
Ignition system is defective - Check ignition and replace faulty components.
Worn cylinder head gasket - Change cylinder head gasket.
Stuck or burned valves - Clean or replace valves.
Damaged cylinder block parts - Replace defective components as required.
Oil filter is dirty - Replace or service oil filter.
| Engine uses too much fuel |
Clogged air filter - Change or service air filter.
Fuel injectors are defective or dirty - Clean or install new fuel injectors.
Spark plug is loose or faulty - Replace or tighten spark plug.
Ignition timing is wrong - Set the ignition timing correctly.
Stuck, worn, or burned valves - Change or clean valves.
Sleeve, rings, or piston are damaged - Replace defective components as required.
Improper valve clearance - Adjust valve clearance.
Weak cylinder compression - Inspect cylinder block and change worn parts.
| Engine oil consumption is too high |
Damaged seals or gaskets - New components need to be installed.
Damaged valve guides or valve stems - Valves replacement required.
Piston rings are seized or worn - Replace piston rings.
Cylinder liner or piston is damaged - Inspect piston and liner, change as required.
| Engine backfires |
Fuel injectors are clogged - Clean or replace fuel injectors.
Clogged fuel lines - Clean fuel system lines.
Ignition timing is incorrect - Adjust ignition timing as required.
Incorrect valve setting - Set the valves properly.
Plugged air filter - Service or change air filter.
____________________________________________________________________________________